They go together well.
I did make one modification by adding a 2mm bearing to the hole where the lever goes up through, I can see this wearing through at a later date.
About Me
- cparkstone
- When i left school back then i was lucky enough to enroll on an engineering apprenticeship. I think this lead me in good stead. I was always one of those children that pulled things apart but actually put them back together again. My first engine given to me at the age of Seven, a Triang Princess Elizabeth. The rest as they say is History. Later in life i got back in to Model Railways and started building Pine Road. This could lead anywhere so i hope you enjoy my Blog.
Wednesday 28 October 2020
The new layout, servo mounts
The postman bought me some servo motor mounts today.
I got them from a guy from eBay.
They are just pin-point bearings drilled through.
Assembled, only another 12 to go. The piece next to the servo is long enough to fit Two micro switches, ideal for frog polarity and anything else you might want to switch.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment